S27 FE 350 FUEL SYSTEM
Engine Control Linkage
18
1
4
5
1
3
2
1. If spring looks like this... 2. then adjust spring to look like this by... 3. holding float firmly and rotating valve counterclockwise to seat spring in
seat of float bowl 4. Check for coil located in groove above both ears. 5. Check for spring seated in recess of float.
538
Figure 18-5
Inspect Float Valve/Spring Assembly – Adjust If Required
10. Install the fuel bowl retaining screw and tighten it to 61 in-lb (6.9 N·m).
11. Write the size of the main jet on the fuel bowl with an indelible ink marker. This should be written in a location that
will be visible when the carburetor is installed on the engine.
12. Install the carburetor on the engine
.
12.1. Attach the throttle return spring (11) to the carburetor and then to the throttle bracket (4) just before
positioning the carburetor and securing it to the engine.
12.2. Install the intake pipe gasket (16) (check for proper orientation) and intake pipe (17).
12.3. Install the carburetor retaining nuts (19) and tighten them to 50 in-lb (5.7 N·m).
13. Connect fuel supply line (26) and tighten screw clamp to 9 in-lb (1.0 N·m)
14. Install carburetor vent line (14) and clamp (13).
15. Install the governor cable (30).
16. Install the intake hose (23) and secure with hose clamp.
NOTE:
Make sure the intake hose is not twisted during installation.
17. Turn fuel shut-off valve on top of fuel tank to the ON position
(Figure 18-18, Page 18-26 or Figure 18-19,
.
18. Connect battery.
See Connecting the Battery – Gasoline Vehicles, Section 1, Page 1-3.
19. Test drive the vehicle.
ENGINE CONTROL LINKAGE
See General Warning on page 1-1.
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
Page 18-5
