10
Engine Oil – Gasoline Vehicle
PERIODIC MAINTENANCE
26
Figure 10-5
Remove Engine Oil Filter
10. Use a clean rag and wipe the oil filter mounting bracket surface clean where the oil filter gasket seats.
11. Install a new oil filter (CCI P/N 1016467) onto the engine oil filter port. Apply a light coat of white lithium NLGI
Number 2 grease (Dow Corning
®
BR2-Plus or equivalent) or new engine oil to the rubber seal around the
outside surface of the filter before attaching it to the oil filter port
. This will help seal the filter to
the oil filter mounting bracket.
NOTE:
Use only Club Car oil filters (CCI P/N 1016467) designed for this engine.
12. Tighten the oil filter by hand until tight. Do not use a band wrench or channel lock plier to tighten.
13. Remove the dipstick and add engine oil into the dipstick port. Use a funnel or pour spout to direct the oil into the
dipstick port. With filter change, the engine requires 38 ounces (1.12 liters) of oil per change. Refer to oil viscosity
guidelines for selection of oil grade
. Replace the dipstick.
SAE 5 W-30
SAE 10W-30/ SAE 10W-40
SAE 30
SAE 40
27
Figure 10-6
Coat Oil Filter Rubber Seal
213
Figure 10-7
Oil Viscosity Chart
14. Connect battery and spark plug wire(s).
See Connecting the Battery – Gasoline Vehicles, Section 1, Page 1-3.
15. With the Forward/Reverse handle in the NEUTRAL position, start and run the engine for a few minutes. Observe
both the drain plug and the oil filter from under the vehicle and watch for oil leaks. If leaks appear, begin with step
1 and repeat the appropriate step for either or both items to correct the problem.
16.
Remove the dip stick and check the engine oil as a final step. Replace the dip stick.
Page 10-10
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
