Fueling Instructions
2005 Carryall 272/ Carryall 472 Gasoline Vehicle Owner’s Manual
Page 35
17. With the Forward/Reverse handle in the NEUTRAL position, start and run the engine for a few minutes.
Observe both the drain plug and the oil filter from under the vehicle and watch for oil leaks. If leaks
appear, begin with step 1 and repeat the appropriate step for either or both items to correct the problem.
18. Remove the dip stick and check the engine oil as a final step. Replace the dip stick.
OIL VISCOSITY
Choose the viscosity according to the temperature as indicated by the oil viscosity chart (Figure 26).
NOTE: Using multi-grade oils (5W-20, 10W-30, and 10W-40) will increase oil consumption. Check oil level
more frequently when using them.
FUELING INSTRUCTIONS
See General Warnings on page 10.
∆
DANGER
• Turn the key switch to the OFF position before fueling.
• Do not pour gasoline into fuel tank when the engine is hot or while it is running.
• To help avoid electric arc caused by static electricity, the fuel storage/pumping device must be
grounded. If the pump is not grounded, the vehicle must be grounded to the pump before and
during the fueling operation.
• If vehicle has an all-weather enclosure installed, be sure the fuel tank is properly vented as
shown (Figure 27, Page 36 or Figure 28, Page 36).
• To help avoid the possibility of fire, clean up any spilled gasoline before operating the vehicle.
∆
CAUTION
• To allow for expansion, do not fill higher than one inch (2.5 cm) from the top of the fuel tank.
Avoid spilling fuel.
Figure 26 Oil Viscosity Chart
-20
°
C -10
°
C
0
°
C
10
°
C
20
°
C
30
°
C
40
°
C
-4
°
F
14
°
F
32
°
F
50
°
F
68
°
F
86
°
F 104
°
F
SAE 5W-20
SAE 10W-30/SAE 10W-40
SAE 30
SAE 40
