MC012C-BS00 UNITIZED TRANSAXLE WITH DIFFERENTIAL LOCK
Unitized Transaxle Removal
Page 16-6
2006-2010 Turf/Carryall 272/472 and XRT 1200/1200 SE Maintenance and Service Manual
16
UNITIZED TRANSAXLE REMOVAL
See General Warning, Section 1, Page 1-1.
ý
WARNING
• To perform this procedure, the hydraulic system must be opened. As a result, the brakes must
be bled after the correct installation of the brake components. Failure to bleed the brakes
could result in decreased braking performance due to air being trapped in the hydraulic
system. Use only DOT 5 brake fluid. See Bleeding the Hydraulic Brake System, Section 6,
Page 6-31.
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in the NEUTRAL posi-
tion. Chock the front wheels.
2. Disconnect battery and spark plug wire(s).
See Disconnecting The Battery on page 1-3.
3. Close the fuel shut-off valve on fuel tank.
See Fuel Shut-Off Valve, Section 14, Page 14-28.
4. Detach all wires, hoses, etc. connecting the powertrain to the vehicle.
4.1. Disconnect the carburetor vent tube from the carburetor
Figure 16-8 Differential Axle and Wheel Hub Assembly
TYPICAL
8 PLACES
92
95
94
89
88
87
90
80
82
84
85
83
81
86
Summary of Contents for CARRYALL 272
