![background image](http://html1.mh-extra.com/html/club-car/carryall-272/carryall-272_maintenance-and-service-manual_2626763275.webp)
MC012C-BS00 UNITIZED TRANSAXLE WITH DIFFERENTIAL LOCK
Unitized Transaxle Installation
2006-2010 Turf/Carryall 272/472 and XRT 1200/1200 SE Maintenance and Service Manual
Page 16-19
16
19. Connect the park brake cables.
See Park Brake Cable Installation, Section 6, Page 6-34.
20. Use a 3/8-inch flare nut wrench to connect the brake hoses to the left and right rear brake clusters and
bleed the air from the brake lines.
See Bleeding the Hydraulic Brake System, Section 6, Page 6-31.
21. Check the brake system to ensure that there are no leaks and that proper brake operation has been
restored.
See following WARNING.
ý
WARNING
• The brakes must be bled after the correct installation of the brake components. Failure to
bleed the brakes could result in decreased braking performance due to air being trapped in
the hydraulic system. See Bleeding the Hydraulic Brake System, Section 6, Page 6-31.
22. Connect the engine kill switch wire (18-gauge white/black stripe) to the bullet connector at the lower right
front of the engine
23. Install three wire ties to secure the engine kill wire and accelerator cable.
24. Connect the oil level sensor wire (18-gauge yellow) to the jumper wire
.
Figure 16-44 Driven Clutch
Figure 16-45 Snubber
Figure 16-46 Ignition Kill Wire
KEY
SNUBBER
BRACKET
SNUBBER
WHITE/BLACK
WIRE
BLACK
WIRE
Summary of Contents for CARRYALL 272
