TORQUE CONVERTER
Drive Clutch
2006-2010 Turf/Carryall 272/472 and XRT 1200/1200 SE Maintenance and Service Manual
Page 17-7
17
5. Remove the clutch weights.
5.1. Remove the screws and flat washers attaching the weights
.
5.2. Pull the weight assemblies, with pins, from the clutch.
5.3. Remove the plastic washers, weights and wave washer from the pins. Before removing, note the
orientations of the wave washer and of the primary and secondary weights to one another
(Figure 17-12, Page 17-10 and Figure 17-13, Page 17-10)
. Retain all parts.
6. Remove the retaining ring (7) from the shaft of the fixed face assembly (2) and slide the moveable face
(13) off the shaft
See following NOTE.
NOTE:
When the moveable face is removed from the hub of the fixed face, the spiral back-up rings (12)
must be replaced with new ones at time of reassembly
7. Remove the spacer (6), spring (5) and retainer (4). The spring retainer (4) can be removed from the
spring if necessary
.
8. Remove idler bearing if necessary. Use a press to remove the bearing
See
following NOTE.
NOTE:
Do not remove the idler bearing unless it needs to be replaced. If idler bearing is removed, replace
it with a new bearing.
9. Use a scribe or small pick to remove the spiral backup rings (12) from each end of the bore in the fixed
face assembly
See also Figure 17-11, Page 17-9
. Discard the rings.
INSPECTION OF DRIVE CLUTCH PARTS
1. Inspect the idler bearing (3) for smooth rotation or seal damage
.
NOTE:
It is normal for a small amount of grease to be present at the edge of seal.
2. Inspect the bore of the moveable face assembly (13) for scarring or wear. The moveable face assembly
must be replaced if the bore is worn to a diameter of 0.883-inch (22.4-mm) or larger
3. Inspect the steel shaft (2) on the fixed face assembly. There should be no noticeable wear anywhere on
the shaft. Replace the shaft if it is worn, scratched, or damaged.
4. Inspect the thrust washer (11) for wear. If it is worn more than 0.030-inch (0.76-mm), turn it over or
replace it with a new one.
5. Inspect the primary weights and the hub casting for wear. If the primary weights show signs they are
touching the casting, the tips of the weights have worn beyond specification and they must be replaced
6. Inspect the pins on the primary weights. There should be no noticeable wear. Replace them if they are
worn, scratched, or damaged.
7. Inspect the drive belt pulley sheaves for excessive wear or damage. If the sheaves are excessively worn
or damaged, replace the entire fixed face drive assembly.
Summary of Contents for CARRYALL 272
