BODY AND TRIM
Cargo Bed – Electric Lift
4
4
1
6
6
2
2
3
1
5
2475
Figure 4-6
Driver Seat Belt – Homologated Models
SEAT BELT INSTALLATION – HOMOLOGATED MODELS
1.
Driver seat:
Install the seat belt buckle assembly and coiled seat belt assembly to the driver seat as shown
with hardware previously removed except for the lock nut
. Use a new lock nut and
tighten to 33 ft-lb (44.7 N·m).
2.
Passenger seat:
Install the center seat belt buckle assembly to the seat belt bracket with hardware previously
removed except for the lock nut
. Use a new lock nut and tighten to 33 ft-lb (44.7 N·m).
Secure the coiled seat belt assembly on the outside of the ROPS seat support with the shoulder bolt and a
new lock nut
. Orient the assembly with the tang end pointed up slightly and tighten
the new lock nut to 33 ft-lb (44.7 N·m).
CARGO BED – ELECTRIC LIFT
See General Warnings, Section 1, Page 1-2.
TESTING THE BED LIFT MOTOR
Gasoline Vehicles: See Test Procedure 35 – Bed Lift Motor on page 11-38.
Diesel Vehicles: See Test Procedure 36 – Bed Lift Motor on page 12-43.
BED LIFT MOTOR REMOVAL
1.
Make sure the key switch is OFF and the Forward/Reverse handle is in the NEUTRAL position. Remove the
key. Chock the wheels.
2.
Disconnect battery.
See Disconnecting the Battery – Gasoline/Diesel Vehicles, Section 1, Page 1-3.
3.
With the bed in the down position, working from under the vehicle, disconnect the two wires from the connectors
at the electric bed lift motor.
2008-2012 All-Wheel Drive Maintenance and Service Manual
Page 4-13
Summary of Contents for Carryall 295 SE
