Engine Oil – Gasoline Vehicles
Page 42
2007 DS Golf Car Owner’s Manual
10. Use a clean rag and wipe the oil filter mounting bracket surface clean where the oil filter gasket seats.
11. Install a new oil filter (CCI P/N 1016467) onto the engine oil filter port. Apply a light coat of white lithium
NLGI Number 2 grease (Dow Corning
®
BR2-Plus or equivalent) or new engine oil to the rubber seal
around the outside surface of the filter before attaching it to the oil filter port
(Figure 29)
. This will help
seal the filter to the oil mounting bracket.
NOTE: Use only Club Car oil filters (CCI P/N 1016467) designed for this engine.
12. Tighten the oil filter by hand until tight. Do not use a band wrench or channel lock plier to tighten.
13. Remove the dipstick and add engine oil into the dipstick port. Use a funnel or pour spout to direct the oil
into the dipstick port. With filter change, the engine requires 38 ounces (1.12 liters) of oil per change.
Refer to oil viscosity guidelines for selection of oil grade
(Figure 30)
. Replace the dipstick.
Figure 28 Remove Engine Oil Filter
Figure 29 Coat Oil Filter Rubber Seal
Figure 30 Oil Viscosity Chart
1
2
3
°
°
°
°
°
°
°
°
C
°
°
°
°
°
°
°
-20 C -10 C
0 C
10 C
20
C
-4 F
F
32 F
68 F
86 F 104 F
SAE 5W-20
SAE 10W-30/SAE 10W-40
SAE 30
SAE 40
30
40
14
50 F
