S27 FE 350 ENGINE
Crankcase
14
2.
Position the sensor and bracket on inside of crankcase and install two mounting screws.
3.
Connect sensor wire (2) to cord connector (1).
4.
Install screw (3) through wire clamp and into crankcase cover. Tighten to 30 in-lb (3.4 N·m).
1
4
3
2
9
8
5
6
7
528
Figure 14-7
Oil Level Sensor
CRANKCASE COVER INSTALLATION
CAUTION
• Before assembly, make sure parts are clean.
• Do not reuse the gasket. Install a new one.
• Install and tighten crankcase cover bolts as instructed. Failure to do so could cause the cover to
become warped.
1.
Clean the gasket surfaces on the crankcase cover to fit a new gasket during installation and inspect the oil seal
for wear and damage.
2.
Install crankcase cover. Using HANDS ONLY, seat cover completely against the crankcase. If the cover will not
seat, the camshaft is not installed correctly.
3.
Install and finger tighten evenly the eight cover mounting bolts.
4.
Tighten the cover mounting bolts in two steps. First, in the sequence shown, tighten all eight bolts to approximately
130 in-lb (14 N·m). Then, repeating the sequence, tighten them to 250 in-lb (28.2 N·m)
5.
Connect the yellow jumper wire (11) to the cord connector (12)
2009 FE 350 Maintenance and Service Supplement
Page 14-7
