S27 FE 350 FUEL SYSTEM
Engine Control Linkage
16
2.
Push the cable dust shields onto the ends of the cable conduit.
3.
Connect the governor cable to the carburetor throttle at the carburetor.
4.
Connect the governor cable to the governor lever arm (15).
5.
With the governor lever arm loose on the governor shaft, use a 1/8-inch punch or scratch awl to turn the governor
arm shaft counterclockwise until it stops. Then pull the governor lever arm rearward until the carburetor throttle is
in the “wide open throttle” (WOT) position.
6.
While holding the arm and shaft in the fully counterclockwise position, tighten the governor arm lever nut to
36 in-lb (4.0 N·m).
7.
Check engine RPM adjustment.
See Engine RPM Adjustment on page 16-11.
6
14
12
10
15
17
13
11
1
2
2
6
16
5
3
4
542
Figure 16-9
Governor and Accelerator Cables
ACCELERATOR CABLE
Accelerator Cable Removal
1.
Access the engine compartment.
2009 FE 350 Maintenance and Service Supplement
Page 16-9
