11
Test Procedures
TROUBLESHOOTING AND ELECTRICAL SYSTEM
TEST PROCEDURE 23 – Oil Level Sensor
See General Warning on page 10-1.
NOTE:
Keep the battery connected while performing this test procedure.
1.
Place the Forward/Reverse handle in the NEUTRAL position, the neutral lockout switch in the MAINTENANCE
position, turn the key switch to the OFF position, disconnect the spark plug wire, and chock the wheels.
2.
Ensure that the low oil warning light and all connecting wires are functioning correctly.
3.
Drain the engine oil into an approved container and properly dispose of used oil.
4.
Turn the key switch ON, closing the circuit. The low oil warning light should illuminate. If the low oil warning light
does not illuminate, the oil level sensor needs to be replaced.
See Oil Level Sensor Removal, Section 14,
5.
Install a new oil filter and fill the engine with new oil before returning the vehicle to service.
TEST PROCEDURE 24 – Neutral Lockout Switch
See General Warning on page 10-1.
1.
Disconnect battery and spark plug wire(s).
See Disconnecting the Battery – Gasoline Vehicles, Section 10,
2.
Remove the wires from the switch
.
3.
With switch in position 1:
3.1. Check for no continuity between terminals T1 and T2.
3.2. Check for continuity between terminals T2 and T3.
4.
With switch in position 2:
4.1. Check for no continuity between terminals T2 and T3.
4.2. Check for continuity between terminals T1 and T2.
T1
T3
T2
3
2
1
Pedal-Start Vehicle:
T1 – Black/Light Blue Stripe T2
– Black T3 – Black/Yellow Stripe
Key-Start Vehicle:
T1 – Gray T2 – Red T3 – Pink
1. Position 1
2. Position 2
478
Figure 11-41
Neutral Lockout Switch Test
Page 11-40
2009 FE 350 Maintenance and Service Supplement
