16
Engine Control Linkage
S27 FE 350 FUEL SYSTEM
3
540
Figure 16-7
Cam Position – Parallel with Box (Top View)
541
Figure 16-8
Accelerator Rod – Pull Spring Release to
Attach (Bottom View)
7.
Before tightening the jam nuts, set the park brake to the first latch and pawl position and check for proper
activation of switches.
8.
While pressing the accelerator pedal, the following events should occur in exactly the order shown:
EVENT
APPROXIMATE PEDAL TRAVEL
Park brake release
0°-4°
Solenoid activation
4°-8°
Carburetor throttle actuation
8°-12°
9.
While holding the accelerator ball joint with pliers, tighten the jam nuts against the ball joints, accelerator ball joint
first, at each end of the accelerator rod.
10. Check rod adjustment for proper switch activation.
11. After the pedal group and accelerator rod are properly adjusted, adjust the engine RPM setting.
12. Install the electrical box cover and tighten retaining screw to 18 in-lb (2.0 N·m).
GOVERNOR CABLE
Governor Cable Removal
1.
Turn the key switch to the OFF position and remove the key, place the Forward/Reverse handle in the NEUTRAL
position, and chock the wheels.
2.
Access the engine compartment.
3.
Disconnect battery and spark plug wire(s).
See Disconnecting the Battery – Gasoline Vehicles, Section 10,
4.
Disconnect the governor cable (2) at the carburetor throttle
.
5.
Disconnect the governor cable (2) from the governor lever arm (15).
6.
Remove the governor cable (2) from the governor cable engine bracket (11), and governor cable support bracket
(10). Remove the cable (2) from the vehicle.
Governor Cable Installation and Adjustment
1.
Install the cable onto the governor cable support bracket (10) and the engine bracket (11)
.
Page 16-8
2009 FE 350 Maintenance and Service Supplement
