Gearcase Lubrication
2007 Carryall 295 Intellitach and XRT 1550 Intellitach Diesel Vehicle Owner’s Manual
Page 51
Using multi-grade oils (5W-20, 10W-30, and 10W-40) will increase oil consumption. If multi-grade oil is used,
check the oil level more frequently.
GEARCASE LUBRICATION
NOTE: Dispose of used oil according to the environmental laws and regulations for your area.
LUBRICATION LEVEL CHECK FOR FRONT DIFFERENTIAL, TRANSMISSION, AND
REAR DIFFERENTIAL
Each gearcase component is equipped with two oil port plugs (1 and 2)
. When the vehicle is on a level surface, use the level indicator hole (upper plug) (1) as a lubricant
level indicator. Lubricant level should be even with the bottom of level indicator hole (1).
LUBRICATION CHANGE FOR FRONT DIFFERENTIAL, TRANSMISSION, AND REAR
DIFFERENTIAL
Use the lower plug (2) for drainage
(Figure 56, Figure 57, or Figure 58)
. Remove both plugs to allow the
lubricant to drain faster.
See preceding NOTE.
Front differential:
Clean and install the drain plug (2) and washer before filling the front differential with new lubricant
. Tighten the drain plug to 9 ft-lb (12 N·m). Use a funnel when filling the front differential through
the lubricant level indicator hole (1).
See Periodic Lubrication Schedule on page 45.
Tighten the level indi-
cator plug to 10 ft-lb (14 N·m).
Figure 55 Oil Viscosity Chart – Diesel Vehicles
SAE 10W-30/SAE 10W-40
SAE 20
SAE 30
SAE 10W
