Controls and Indicators
2007 Carryall 295 Intellitach and XRT 1550 Intellitach Diesel Vehicle Owner’s Manual
Page 15
HYDRAULIC CONTROLS
ý
WARNING
• The hydraulic system is active as soon as the start key is in the ON position; the vehicle
engine does not need to be running.
• To avoid accidently engaging the hydraulic system, press the joystick ON/OFF rocker switch
(18) to the OFF position (Figure 4). All hydraulic interface controls, (joystick, float, and
auxiliary) are disabled while the switch is in the OFF position.
CAUT ION
• Do not tamper with the hydraulic power unit settings. These settings are factory preset, and if
adjusted will void the warranty.
• Do not operate the attachment arm without the engine running, as battery discharge will
occur.
Movement of the joystick (1)
controls the hydraulic cylinders for the lift and tilt func-
tions.
See following NOTE
.
NOTE: The joystick will not activate the attachment arm unless the start key is ON and the joystick ON/
OFF rocker switch is in the ON position (Figure 4).
The joystick is an ON/OFF control. It does not have proportional control.
Activating the joystick with the engine OFF but the key switch ON will cause battery discharge. The
hydraulic system is powered by an electric motor. Limit the time that you use the joystick in this
manner to avoid discharging the battery.
When engaged in heavy attachment use, avoid the continued use of electrically powered devices
(i.e. bedlift, worklights, lower fan speed on heater, etc.). Either drive the vehicle or allow it to idle
occasionally to let the battery recharge.
Figure 6 Lift Function
Figure 7 Tilt Function
102849801
3
2
2
3
1
ACTIVATE
TOGETHER
FOR FLOAT
FLOAT
AUX HYD
5
4
102849801
AUX HYD
FLOAT
ACTIVATE
TOGETHER
FOR FLOAT
1
6
5
5
6
