Controls and Indicators
Page 16
2007 Carryall 295 Intellitach and XRT 1550 Intellitach Diesel Vehicle Owner’s Manual
Attachment Arm Operation
Pull the joystick (1) backward (2) to raise the attachment arm
.
Push the joystick (1) forward (3) to lower the attachment arm.
Attachment Arm Float Position
To activate the float function, push the right-side of the rocker switch (4) and at the same time, push the joy-
stick (1) forward (3). The light (5) on the float switch will be illuminated when the float function is activated.
Once the float function is activated, release the switch and the joystick
To disengage the float function, pull the joystick (1) backward. The light (5) will no longer be illuminated.
Tilt Operation
1. Move the joystick (1) to the right (5) to tilt the bucket forward
2. Move the joystick (1) to the left (6) to tilt the bucket back.
Front Auxiliary Hydraulics Operation (If Equipped)
CAUT ION
• Never use unapproved devices (i.e. hydraulic hand tools) with the auxiliary hydraulic system.
Failure to comply may result in premature failure of the power unit and drain the battery.
1. To rotate the attachment to the right, push the auxiliary hydraulic rocker switch (1) to the right (2)
2. To rotate the attachment to the left, push the auxiliary hydraulic rocker switch (1) to the left (3).
NOTE: After installing the attachment to the auxiliary hydraulics, cycle the cylinders until they are in the
retracted position and then check the fluid level in the hydraulic pump reservoir.
Figure 8 Front Auxiliary Hydraulics Operation
102849801
AUX HYD
FLOAT
ACTIVATE
TOGETHER
FOR FLOAT
3
3
2
2
1
