Roll-Over Protective Structure (ROPS) and Safety
Belts
2007 Carryall 295 Intellitach and XRT 1550 Intellitach Diesel Vehicle Owner’s Manual
Page 17
Quick Couplers (If Equipped)
To Connect:
Remove dirt or debris from the surface of both the male and female couplers and from the out-
side diameter of the male coupler. Install the male coupler (1) into the female coupler. Full connection is made
when the ball sleeve (2) slides forward onto the female coupler. Visually check the couplers for corroding,
cracking, damage or excessive wear. If any of these conditions exist, the coupler(s) must be replaced.
To Disconnect:
Hold the male coupler (1). Retract the sleeve (2)
on the female coupler until the
couplers disconnect. Install the dust covers (if equipped) on the couplers after they have been disconnected.
ý
WARNING
• Hydraulic fluid, tubes, fittings and quick couplers can get hot when running vehicle and
attachments. Be careful when connecting and disconnecting quick couplers.
Relieve Hydraulic Pressure
Hydraulic pressure in the auxiliary circuit can make it difficult to connect or disconnect the hydraulic couplers.
With the engine stopped (key switch OFF) and attachment flat on the ground, move the auxiliary hydraulic
switch (1) to the right (2) and to the left (3)
several times. This will relieve hydraulic pressure that
is in the auxiliary circuit.
ROLL-OVER PROTECTIVE STRUCTURE (ROPS) AND SAFETY BELTS
The Carryall 295 IntelliTach and XRT 1550 IntelliTach is equipped with a Roll-Over Protective Structure
(ROPS). Safety belts are provided for each occupant.
See following WARNING.
ý
WARNING
• The ROPS must be properly installed before operating the vehicle. Club Car strongly urges
that the vehicle’s occupants be properly restrained at all times with the safety belts provided.
Pregnant woman: Consult your doctor for specific recommendations. The safety belt should be worn securely
and as low as possible over the hips and not on the waist.
Figure 9 Quick Couplers
2
1
