Attachments and Buckets
Page 30
2007 Carryall 295 Intellitach and XRT 1550 Intellitach Diesel Vehicle Owner’s Manual
5. Enter the vehicle and fasten your seat belt. Start the engine.
6. Tilt the attachment interface forward.
7. Release the park brake, then move vehicle backward, away from the bucket or attachment
8. Stop the engine, put the Forward/Reverse Handle in NEUTRAL, engage the park brake, unfasten your
seat belt, and exit the vehicle.
9. Move the attachment interface lever fully to the right. This will release the spring tension from the lever.
OPERATING WITH ATTACHMENTS
New operators must operate the vehicle in an open area without bystanders. Operate the controls until the
vehicle can be handled at an efficient and safe rate for all conditions of the work area.
NOTE: Always warm up the engine before operating the vehicle with an attachment.
If movement of the attachment arm appears to be progressively slowing, the battery must be either
charged or replaced.
After heavy attachment use, always allow the battery to recharge by driving the vehicle.
ý
WARNING
• Keep the attachment arm as low as possible and watch for obstructions.
• Do not travel or turn with the attachment arm up. Turn on level ground. Slow down when
turning.
• Go up and down slopes, not across them.
• Keep the heavy end of the vehicle uphill.
• Do not overload the vehicle.
• Failure to obey warnings can cause the vehicle to tip or roll over and cause injury or death.
Figure 22 Remove Interface from Attachment
Figure 23 Obey Warnings to Avoid Tip Over
Figure 24 Avoid Obstructions
