Attachments and Buckets
Page 32
2007 Carryall 295 Intellitach and XRT 1550 Intellitach Diesel Vehicle Owner’s Manual
3. Raise the attachment arm (B) and tilt the bucket backward (C)
ý
WARNING
• Load, unload and turn on flat level ground. Do not exceed attachment arm rated capacity.
Failure to obey warnings can cause the vehicle to tip or roll over and cause injury or death.
4. Drive backward away from the material.
Using the Float Position
NOTE: The primary function of the float position is for the mower, blade, or broom attachments. To level
the ground using float, the ground must contain loose debris.
1. Raise the attachment arm (B) and tilt the bucket forward (D)
.
2. Push the float rocker switch to the right and the joystick forward (A) until the float is engaged (rocker
switch light will be illuminated). The attachment arm will slowly lower.
ý
WARNING
• When using a bucket, never drive forward when the control for the attachment arm is in float
position.
3. Drive backward to level loose material.
4. Pull the joystick backward (B) to unlock the attachment arm from the float position.
Figure 29 Joystick Position – Using Float
B
C
D
FLOAT
PRESS
TOGETHER
FOR FLOAT
A
