DIESEL ENGINE, MUFFLER, FUEL SYSTEM, AND CLUTCHES
Clutches
2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
Page 13c-33
13C
DRIVEN CLUTCH
See General Warning, Section 1, Page 1-1.
Driven Clutch Removal
1. Turn the key switch OFF and remove the key. Set the park brake. Place the Forward/Reverse handle is
in NEUTRAL.
2. Disconnect the battery cables as instructed.
See WARNING “To avoid unintentionally starting...” in
General Warning, Section 1, Page 1-2.
3. Remove the top air filter hose from the filter canister.
4. Remove the clutch outer cover.
See Clutch Outer Cover Removal on page 13c-35.
5. Remove the drive belt as instructed.
See Drive Belt Removal on page 13c-28.
6. Remove the bolt and washer from the center of the clutch.
7. Remove the driven clutch.
See following CAUTION.
CAUT ION
• Do not hit or tap the clutch with a hammer. Do not pry the clutch. These actions will damage
the clutch.
Figure 13c-33 Driven Clutch Service Tools
SPRING COMPRESSION
NUT (CCI P/N 102606101)
SPRING COMPRESSION
COLLAR
(CCI P/N 102605201)
DRIVEN
CLUTCH
SPRING COMPRESSION
BASE (CCI P/N 102603501)
Summary of Contents for IntelliTach XRT 1550
