WHEEL BRAKE ASSEMBLIES
Rear Brake Cables
2001 Pioneer 900 Gasoline Vehicle Maintenance and Service Manual Page 6-15
6
4. Disconnect brake cables at rear wheels.
4.1. Remove cotter pins (1), clevis pins (2), and E-clips (3) (Figure 6-24, Page 6-15).
4.2. Remove cable (4) from cable support bracket (5).
4.3. Note the routing of the brake cables; the new cables will be installed in the same position.
REAR BRAKE CABLE INSTALLATION
1. Place the new cable ends through the access holes in the frame and into the equalizer (4) and secure
with new E-clips (5) (Figure 6-23, Page 6-15). Route the new cables through the hangers.
2. Place the cables in the cable support brackets (5) and secure with new E-clips (3). Connect the cables
to the brake actuator arms using new clevis pins (2) and cotter pins (1) (Figure 6-24, Page 6-15).
3. Adjust brakes. See Brake Adjustment on page 6-16.
Figure 6-23 Loosen Equalizer Nut
Figure 6-24 Disconnect Cables at Rear Brakes
1
3
2
4
5
1
2
4
3
5
