TORQUE CONVERTER
Drive Clutch
2001 Pioneer 900 Gasoline Vehicle Maintenance and Service Manual Page 17-5
17
DRIVE CLUTCH CLEANING AND INSPECTION
1. Use a dry, lint-free cloth to clean clutch parts.
∆ CAUTION
• Do not lubricate the drive clutch. Lubricants attract dirt and dust, which interfere with proper clutch
operation.
• Use only a dry cloth to lightly wipe the shaft of the fixed face assembly (7) (Figure 17-5, Page 17-6).
Do not use a brush or steel wool. These will damage the surface of the shaft.
• Do not use solvents. Solvents will damage the lubricating characteristics of the bushings.
2. Inspect the belt contact surfaces of the clutch sheaves for wear. If any area of a sheave contact surface
has wear of 0.060 inch (1.52 mm) or more, the clutch should be replaced.
Figure 17-3 Loosen Retaining Bolt
Figure 17-4 Drive Clutch Removal
WARNING
Use Club Car clutch holder
while tightening or loosening drive
clutch retaining bolt.
CLUTCH HOLDER
Hook clutch holder
on boss of pully
located behind drive
clutch...push down
on adjacent
boss with holder.
THREE BOSSES
IN GRAY
DRIVE CLUTCH
RETAINING BOLT
DRIVE CLUTCH
DRIVEN
CLUTCH
Insert drive clutch
puller into drive
clutch, then tighten
puller to remove
hub.
VEHICLE BODY
REMOVED FOR
CLARITY
DRIVE CLUTCH PULLER
(CCI 1014496)
