Single Point Watering System (SPWS)
1
2
3
5
4
5
7
6
8
3
68
Figure 15
Connecting Hose with Filter to Water Source
69
Figure 16
Checking the Water Flow Rate
4.
Completely open the water faucet until the water flows out of the regulator (3), and note the movement of the
red flow indicator balls (6).
See following NOTE.
NOTE:
The water flow rate must be at least two gallons-per-minute for the SPWS to function properly.
This step also eliminates any trapped air from the water hose.
5.
Check the water quality light on the deionizer to make sure the light is green in color, indicating acceptable water
quality. If the light indicates unacceptable water quality, the cartridge must be replaced.
6.
After ensuring adequate water flow rate, press the grey button (7) on the end of the female coupler (8) to
disconnect the purger from the regulator.
Refilling the Batteries
1.
Locate the battery fill coupling (9) on the driver side of the battery compartment, remove the dust cover (10) from
the male connector
(Figure 17)
, and connect the regulator (3)
(Figure 18)
. The water flow will begin immediately.
Villager LSV Owner’s Manual
Page 41
