Chapter 3 - Quick-Start Procedures
3-3
3.2 Operation using Control Terminals
1.
Install a potentiometer on terminals V1, VR, 5G
and connect wiring as shown below.
2.
Apply AC power.
3.
Confirm that the DRV 03 is set at ‘Fx/Rx-1’.
4.
LCD:
Press
[
▲
]
key to move DRV 04.
7-Seg:
Rotate encoder knob until ‘04’ is
displayed.
5.
LCD:
Press
[PROG]
key.
7-Seg:
Press
[PROG/ENT]
key.
6.
LCD:
Press
[
▲
]
key and set at ‘V1’.
7-Seg:
Rotate encoder knob and set at ‘2’.
7.
LCD:
Press
[ENT]
key.
7-Seg:
Press
[PROG/ENT]
key.
8.
Press
[SHIFT/ESC]
key.
9.
Set the frequency by rotating the potentiometer.
10.
Close the FX or RX contact to run the motor.
11.
Open the FX or RX contact to stop the motor.
LCD Display
7-Segment Display
DRV
►
T/K 0.0 A
00 STP 0.00Hz
The DRV LED is ON.
DRV
►
Drive mode
03 Fx/Rx-1
DRV
►
Freq mode
04 Keypad-1
DRV
►
Freq mode
04 Keypad-1
DRV
►
Freq mode
04 V1
DRV
►
Freq mode
04 V1
DRV
►
T/V 0.0 A
00 STP 0.00Hz
DRV
►
T/V 0.0 A
00 STP 60.00Hz
The PROG/ENT LED is turned ON.
The PROG/ENT LED is turned ON.
The PROG/ENT LED is turned OFF.
The FWD or REV LED starts blinking.
The RUN LED starts blinking.
The STOP/RESET LED starts blinking. The STOP/RESET LED starts blinking.
1
㏀
, 1/2 W
P1 P2
JOG
CM
P3 FX RX NC
CM BX
RST
I
VR VI
FM 5G
Summary of Contents for 30 HP30
