42
• Protect the machine against hard blows! Do not
drop the machine! If the machine was exposed
to hard blows, make sure immediately that no
fuel is leaking (risk of fire and explosion!)
• Check the fuel system regularly for leaks or
defective parts.
• Make sure that no persons or animals are within
your work area when you start working.
• Before using the machine on surfaces to be
trimmed, search them for animals and objects.
Remove all objects, which could be flung by the
machine. Remove all long objects which might
become entangled with the trimming tool.
• Make sure there are no obstacles in your work
area.
• Ensure that your machine has been fully and
properly assembled.
• Check that the machine works properly and
make sure, in particular, that its rotating parts sit
tightly and properly.
• The machine will vibrate during operation. This
may cause its screws and parts to loosen.
Therefore, check all screws and parts for tight-
ness.
• Symbols located on your machine may not be
removed or covered. Replace any information on
your machine immediately that it becomes illeg-
ible.
Personal protective clothing
Your machine at a glance
Gasoline brushcutter
1.
Operating handle
2.
Shoulder strap lug
3.
Motor
4.
Operating bar
5.
Top shaft tube
6.
Connection piece
7.
Bottom shaft tube
8.
Protective hood
9.
Trimming head
Operating handle
10. Throttle
11. Ignition switch
12. Throttle stop
13. Fuel lever lock
Motor
14. Pull starter
15. Air filter casing
16. Choke lever
17. Ignition cable with spark plug
18. Exhaust silencer
19. Filler opening for fuel mix
20. Fuel pump
What is included
• Instructions for use
• Top shaft tube with motor
• Bottom shaft tube with trimming head
• Impact knife (with transport guard)
• Filament spool
• Protective hood
• Operating bar
• Shoulder strap
• Bag with small parts
Installation
Read the instructions for use prior
to operating the machine
Danger due to foreign bodies being
thrown out.
Keep unauthorised persons away
from the area you are working in.
Hazard due to hot surfaces!
Risk of cuts!
Petrol is highly flammable. Before
topping up fuel, allow the motor to
cool down for at least 5 minutes.
Wear safety goggles
Wear ear defenders
Wear a dust protection mask
Wear protective gloves
Wear safety shoes
Wear close-fitting work clothes
Note:
should any part be missing or dam-
aged, please contact your dealer.
DANGER! Risk of injury during opera-
tion!
Any inappropriately installed parts
may cause serious or deadly injuries when
using the machine. This machine must not
be operated unless all parts have been fully
and tightly installed and no part is dam-
aged!
– Therefore read this chapter completely
before installing any parts!
– Make sure to install the parts com-
pletely and carefully.
– Use tools if specified.
GB
Motorsense_401118_401119.book Seite 42 Donnerstag, 7. April 2016 2:28 14
Summary of Contents for 401 118
