33
Risks caused by vibrations
The vibration values specified in the technical
data represent the main uses of the device.
The actual existing vibrations during use may
deviate from these as a result of the following
factors:
• Incorrect use of the product;
• Unsuitable tools inserted;
• Unsuitable material;
• Insufficient maintenance.
You can reduce the risks considerably by fol-
lowing the tips below:
– Maintain the device in accordance with
the instructions in the operating instruc-
tions.
– Avoid working at low temperatures.
– When it is cold, make sure your body and
your hands, in particular, are kept warm.
– Take regular breaks and move your
hands at the same time to promote circu-
lation.
• Symbols appearing on your product may
not be removed or covered. Information
on the product that are no longer legible
must be replaced immediately.
Personal safety equipment
Your machine at a glance
1. On-Off switch
2. Dust container
3. Sanding plate
4. Lock for front handle
5. Front handle
Scope of supply
• Random orbital sander
• Sanding discs (2×)
• Instructions for use
Commissioning
Fitting the sanding sheet
The fixture of the sanding disc takes place by
means of hook and loop adhesion.
– Carefully align the sanding disc and press
it firmly onto the sanding plate.
Setting the angle of the front handle
– Loosen bolt (4).
– Tilt the front handle (5) to the required
position.
– Retighten bolt (4).
CAUTION!
Risk of injury due to vibrations!
Vibrations may, in particular for per-
sons with circulation problems,
cause damage to blood vessels and/
or nerves.
If you notice any of the following
symptoms, stop working immedi-
ately and consult a doctor. Numb-
ness of body parts, loss of sense of
feeling, itching, pins and needles,
pain, changes in skin colour.
Read and observe the operating in-
structions before commissioning.
Wear a dust protection mask when
the work develops a lot of dust.
Wear protective glasses when using
abrading equipment.
Note:
If any one of the parts is missing or
damaged, contact the retailer.
Note:
Both perforated and unperforated
sanding sheets can be used. Dimen-
sions:
Note:
Position perforated sanding sheets
so that the holes in the sanding plate
and the sanding sheet coincide.
GB
Exzenterschleifer_450211.book Seite 33 Dienstag, 3. Dezember 2013 9:25 09
