Protective packaging
• The stainless steel surfaces of your new
cooker hood are covered with foil to
protect them from scratches during
transport and the corners of the glass
plates have protective caps on them.
Remove the protective foil and caps just
before permanently securing the cooker
hood.
• Also, remove styrofoam and protective
wrapping from the motor, inside the
appliance.
Measurement diagram
Installation with vent kit (not supplied)
•
To use the exhaust operation, a wall
breakthrough is required with a diameter
of at least 155mm. We recommend that
you let a specialist (electrician) perform
the wall breakthrough (core drill hole).
• The shorter the vent kit is and the less
bends it has, the more efficient the
cooker hood will be.
• Official regulations may vary from region
to region. In case of doubt, we
recommend asking your local chimney
sweeper for advice.
• If you have an outlet to the outside, your
cooker hood can be connected by means
of an ex traction duct (enamel, aluminum,
f lexible pipe or inf lammable material
with an interior diameter of 150mm).
• The cooker hood should be placed at a
distance of 40~80cm above the cooking
place for best effect.
