Operating Instructions
AceroDURO
CNC-STEP GmbH & Co. KG ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Page 57
Support: +49 (0)2831/91021-50 15/05/2020
Fig. 25: Tool holder with milling
1 Tool, for example milling motor with 43mm EUROneck
(Fig. 25/1) insert in the tool holder (Fig. 25/2) on the Z
carriage.
2 Tighten screw (Fig. 25/3) lightly until a clamping is done
3 Check milling motor for tightness in the accessory holder.
NOTE:
Property damage caused by excessive tightening!
When excessive tightening the screw for mounting the milling motor, the main
bearing of the cutter motor may be damaged.
•
Never tighten the screw (Fig. 25/2) for fixing the milling motor, excessively.
Only use the short side of an allen key for manual tightening!
6 . 4
I n i t i a l s t a r t - u p
Personnel:
•
Specialist personnel
1
Make sure that the machine is installed and aligned.
2
Ensure that the stepper motor, and control lines are connected to the stepper motor controller
3
Make sure that the computer is connected to the stepper motor control of the machine.
4
Ensure that required accessory is installed and connected to the power supply.
5
Ensure that the appropriate software is installed on the PC.
6
Ensure the tightness of all connections.
NOTE:
The individual materials have different coefficients of expansion. At an ambient
temperature of 20-25 ° C it is ensured that no significant impacts occur during
processing. Therefore, it is recommended to maintain an ambient temperature of 20-
25 ° C when operating the machine.
2
1
3
