Operating instruction
High-Z T-Series
Siemensstrasse 13-15
D-47608 Geldern Tel. +49 (0)2831/91021-20
Page 10
15.02.2014
2.2.2
Dangers by mechanics
Rotating tools
WARNING:
Risk of injury from rotating tools!
Clamped tools such as milling spindles can lead to severe personal injury
or material damage.
Before the start of any work, ensure that all covers and protective
devices are correctly installed and function correctly.
Never touch moving tool during operating process!
Before exchanging tools, always pull power plug of the milling motor
or turn off the machine and secure against restarting.
Axis motion
WARNING:
Risk of injury by axis motion!
Collision by people with components of the machine (Y-bridge, Units,
turntable with work piece, tools) can cause severe injuries.
Body parts are kept away from moving components and axis limit
switches.
Do not reach into gaps between trapezoidal screws and adjacent
components.
Do not reach into gaps between unit and Y-bridge.
Only work on the machine when it is idle.
Only work with personal safety equipment.
Falling materials
WARNING:
Injuries by falling materials!
During operation chips, tools (or parts of it) could be thrown out
uncontrollably or cause severe injuries to skin and eyes.
Wear face shield or fully closed and tight-fitting goggles, protective
clothing, protective gloves and safety shoes.
If particles enter your eyes, immediately get medical attention!
