10
methods:
①
Uninstall MACH3 software, change the MACH3 of other version, and do installation test (because
some main board parallel ports are not compatible with MACH);
②
Check whether your parallel port is normal, and please change another set of qualified desktop
computer and do test.
③
After install MACH3, if you have opened the software without rebooting the computer first, you must
completely uninstall the software and reinstall it.
④
If three step motors cannot self-locking after the control box is electrified, please contact with your
dealer in time.
■
To use your engraving machine
◆
Primary engraving practice: Engraving of graphic pictures and texts
Let's do the primary engraving practice by taking
the right picture as an example. This is a simple
graphic engraving of pictures and texts, and it is
also the main purpose of engraving machine.
●
Step one: Clamp materials
According to the picture below, fix the materials
prepared for engraving on the operating platform of
engraving machine;
●
Step two: Tool setting
"Tool setting" means that after clamping the materials, move the cutter to the initial position set by the
program and the surface of the materials to be engraved; at the beginning of learning engraving, because we
are not familiar with the concept of coordinate, we should set all the initial points of engraving at the center of
the material. As the picture shows that the intersection of diagonal lines is the initial point.
