eVenue Thunder
23
H a r d w a r e O p e r a t i o n
ePod
Operate your ePod(s) using the procedures detailed on the following pages.
Commando-e Remote
This section outlines how to operate the Commando-e Remote. The Commando-e Remote is considered the key to the ePod’s motion
control system. The control system will not function when the Commando-e Remote is not plugged in, and will not operate when it is
unplugged.
1.
Flashlight
: Activates when Brake button is held for one second. Deactivates when
Brake is held for one second. (Operates only when plugged into the ePod.)
2.
Brake
: Indicator LED for ePod Brake On/Off
3.
Ready
: Indicator LED that ePod is ready for deployment
4.
Arrows
: Elevates and lowers the Upper Speaker Array
5.
Rack Tilt
: Tilts the Upper Speaker Array
6.
Presets
: Store up to four specific Upper Speaker Array positions
Connecting the Commando-e Remote
Plug in the Commando-e Remote to the “Remote” connector on the I/O connection panel, which is located on the side of your ePod.
When connecting or disconnecting this remote, the ePod will beep two times.
Using the Commando-e Remote
When using the Commando-e Remote, hold the selected positioning button and release when it’s in the desired position.
For initial use of the Commando-e Remote with an ePod, it will beep four times to warn of movement. After the initial use, the
beeping will stop, if used continuously. When the Commando-e Remote is not used for 10 seconds and use resumes, it will beep four
times before moving.
Note:
Releasing the button(s) will stop the Upper Speaker Array’s movement in its current position.
Creating and Using Presets
Using the Commando-e Remote and the Sound Coverage information on page 25 of this manual, set your Upper Speaker Array
and actuator in the desired position. To create an individual preset for buttons 1, 2, 3, or 4, press and hold the Brake and Ready
buttons at the same time for four seconds until the Commando-e Remote beeps twice. Then, hold the specific numbered button until
it beeps twice.
The Commando-e Remote can be preset into a Travel Ready position for easy travel preparation.
Note:
Once a preset is determined, it will remain in the Commando-e Remote’s memory even when used on different ePods.
Figure 32: Use the Commando-E Remote to control the
ePod’s Motion Control System.
1
5
4
3
2
6