21
Appendix E: LonBuilder Installation
This section describes the steps needed to install a ROUTER-LL into your
LonWorks network using Echelon’s LonBuilder Developer’s Workbench.
See the LonBuilder User’s Guide (078-0001-01 Revision 3, Echelon Corp.)
for complete details on router installation.
Define the IP Channel
From the Navigator window, select
Network
and then
Channel
. Select
Create
to open the Channel Create window, enter a name of your
choice, and then enter the following values:
Std Xcvr Type:
Custom
Comm Mode:
Special Purpose
Comm Rate:
1250 Kbps
Num Priorities:
0
Min Clock Rate:
10 MHz
Avg Packet Size:
15
Osc Accuracy:
200 ppm
Osc Wakeup:
0 usec
Select the
More...
button to set the Comm Mode Specific parameters.
Channel Bit Rate:
[configurable] bps
Alternate Bit Rate:
0 bps
Wakeup Pin Dir:
Input
Xcvr Controls Preamble:
Yes
General Purpose Data:
00 00 00 00 00 00 00
Allow Node Override:
No
Select the
More...
button to set the Layer 1 Time Factors.
Rcv Start Delay:
[configurable] bits
Rcv End Delay:
0.0 bits
Indeterminate Delay:
0.0 bits
Minimum Interpacket:
0.0 bits
Preamble Length:
0.0 bits
Use Raw Data?
No
Raw Data Clock Rate:
10 MHz
Select
OK
and then
Save
to create the new channel.
The Channel Bit Rate
and
Rcv Start Delay
parameters depend
upon the speed of your IP network. See Appendix B: Communications
Parameters
for guidelines on setting these values.
Summary of Contents for ROUTER-LL
Page 1: ...Coactive ROUTER LL LonTalk Ethernet Backbone Router User s Manual Version 2 0 4 RTLL DC 00001 ...
Page 27: ...26 ...
Page 28: ...27 ...
Page 29: ...28 ...
