HANDBOOK (V
4.0)
COMPLETE CONTROL SYSTEM GEN2
37
ADD DATA
Clicking the “Add Data” button is how you can add calibration muscle
signal data for the selected motion. New data will be combined with
already-existing data for this motion in a way that should adapt the
control for better robustness. Once the button is pressed, an empty
circle appears. As you hold your muscle contraction steady for this
motion, the circle will begin filling up with orange segments. Hold your
signals until the whole circle fills.
RESET
Clicking the “Reset” button will set this motion to a blank starting state
while leaving the other calibrated motions as-is. The control memory
for the affected motion is now empty and it will have to get at least one
calibration to be controlled again.
REPLACE DATA
(ONLY SHOWN WHEN ADAPTIVE ADVANCE IS “OFF”)
Clicking the “Replace Data” button is how you can replace calibration
muscle signal data for the selected motion. The existing data for this
motion will be discarded and the new data you provide will be used to
recalibrate your control. Once the button is pressed, an empty circle
appears. As you hold your muscle contraction steady for this motion,
the circle will begin filling up with orange segments. Hold your signals
until the whole circle fills.
The Control Coach
®
“Check Engine” Light
When sensors in your car determine there is something important that you need to
know for improving the performance and reliability of your ride, you get a Check Engine
light to let you know.
Control Coach
®
of the Coapt system has its own light to let you
know there is helpful performance information available—the LED on the
Complete
Calibrate
button (on your socket) will beckon with a slowly blinking white light to
indicate the helpful
Control Coach
®
messages are waiting for you in the Coapt
Complete ControlRoom
software application. Your Coapt “Check Engine” light comes
on whenever the overall
Control Coach
®
rating drops below a set value (the threshold
for this is adjustable in the Coapt
Complete ControlRoom
).