HANDBOOK (V
4.0)
COMPLETE CONTROL SYSTEM GEN2
38
BUTTON SOUNDS & LED COLORS
Somewhere on the surface of the prosthesis, you will have access to the Coapt
Complete Calibrate
button. This
oval unit has one pressable button, a Coapt logo, a multi-colored LED, and it can make a series of tones for you
to hear. This reference section helps you with what all those colors and sounds mean.
Power Up
One short beep and a corresponding
GREEN
flash
The Coapt system has just powered on and “booted”. You should see and hear this about 1
second after each time your prosthesis is turned on.
Low Power Source
Double
RED
Blink
Low power source. The Coapt system won’t have as much view into the health of your
battery as the other prosthesis components should, but the double red blink will let you
know the source power is dangerously low for Coapt to keep operating for much longer.
Reset State
Solid
MAGENTA
Reset state. The Coapt system is in a blank/empty starting state. Calibration will have to be
performed to gain control of the prosthesis.
Calibration Start
One high-pitched beep after the button has been depressed for 2 seconds (LED is solid
CYAN
while the button is being pressed).
This indicates Prosthesis Guided Calibration is beginning. Letting the button go after this
single beep will start the calibration routine.
Calibration Recording
Solid
GREEN
periods
Recording. You will notice the LED green at times during Calibration. When it is lit as green,
your signals are being recorded. Periods of no light between the green phases are when you
can relax.
