28
The Heat Icon
takes you to a screen where you control
the Heat Mode and the Temperature Range.
If there is a right arrow at the bottom of the screen, it
takes you to the next page.
Page Left | Page Right
Page up | Down
If an Up or Down button is shown and pressed when
on a page with a text list, the list can be scrolled a page at
a time.
Page Up
Page Down
Off
On
Running
High
104 F
Cleanup
Cycle Ozone
Spa State
Temp Range
Temp Limit
Temperature
78 F
The Settings Screen
Programming, etc.
The Settings Screen is where all programming and other
spa behaviors are controlled. Each icon on the Settings
screen takes you to a different screen, where one or more
setting may be viewed and/or edited.
Dual Temperature Ranges
High vs. Low
This system incorporates two temperature range settings with
independent set temperatures. The specific range can be
selected on the Settings screen and is visible on the Main Screen
in the upper left corner of the display. These ranges can be used
for various reasons, with a common use being a “ready to use”
setting vs. a “vacation” setting. Each range maintains its own set
temperature as programmed by the user. This way, when a
range is chosen, the spa will heat to the set temperature
associated with that range.
•
High Range can be set between 80°F and 104°F.
•
Low Range can be set between 50°F and 99°F.
More specific Temp Ranges may be determined by the
Manufacturer.
Freeze Protection is active in either range.
Heat Mode
Ready vs. Rest | Circulation Mode | Ready-in-Rest Mode
Heat Mode – Ready vs. Rest
In order for the spa to heat, a pump needs to circulate water through
the heater. The pump that performs this function is known as the
“heater pump.”
The heater pump can be either a 2-speed pump (Pump 1) or a
circulation pump.
If the heater pump is a 2-Speed Pump 1, Ready Mode will circulate
water every 1/2 hour, using Pump 1 Low, in order to maintain a
constant water temperature, heat as needed, and refresh the
temperature display. This is known as “polling.”
Rest Mode will only allow heating during programmed filter cycles.
Since polling does not occur, the temper-ature display may not show
a current temperature until the heater pump has been running for a
minute or two.
When the heater pump has come on automatically (for example for
heating) you can switch between low speed and high speed but you
cannot turn the heater pump off.
OWNER’S MANUAL
2022
CASCADE II
