24
OWNER’S MANUAL
2017
ADDITIONAL SETTINGS
PREFERENCES
The Preferences Menu allows the user to change certain parameters
based on personal preference.
TEMP DISPLAY
Change the temperature between Fahrenheit and Celsius.
TIME DISPLAY
Change the clock between 12 hr and 24 hr display.
REMINDERS
Turn the reminder messages (like “Clean Filter”) On or Off.
CLEANUP
Cleanup Cycle Duration is not always enabled, so it may not appear.
When it is available, set the length of time Pump 1 will run after each
use. 0-4 hours are available.
DOLPHIN II AND DOLPHIN III (APPLIES TO RF DOLPHIN ONLY)
When set to 0, no addressing is used. Use this setting for a Dolphin II or
Dolphin III which is factory set for no address by default. When set be-
tween 1 and 7, the number is the address. (See the Dolphin manual for
details.)
COLOR
Pressing the Select Button when Color is highlighted will cycle through 5
background colors available in the control.
LANGUAGE
Change the language displayed on the panel.
INFORMATION
SYSTEM INFORMATION
The System Information Menu displays various settings and identifica-
tion of the particular system. As each item in the menu is highlighted, the
detail for that item is displayed at the bottom of the screen.
Software ID (SSID)
Displays the software ID number for the System.
System Model
Displays the Model Number of the System.
Current Setup
Displays the currently selected Configuration Setup Number.
Configuration Signature
Displays the checksum for the system configuration file.
Heater Wattage as Configured in Software
Displays a heater kilowatt rating as programmed into the control system
software.
Heater Type
Displays a heater type ID number.
Dip Switch Settings
Displays a number that represents the DIP switch positions of S1 on the
main circuit board.
Panel Version
Displays a number of the software in the topside control panel.
GENERAL MESSAGES
Most messages and alerts will appear at the bottom of the normally used
screens. Several alerts and messages may be displayed in a sequence.
Some messages can be reset from the panel. Messages that can be
reset will appear with a “right arrow” at the end of the message. This
message can be selected by navigating to it by pressing the Select but-
ton.
– – –°F – – –°C
Water Temperature is Unknown
After the pump has been running for 1 minute, the temperature will be
displayed.
Possible freezing condition
A potential freeze condition has been detected, or the Aux Freeze
Switch has closed. All water devices are activated. In some cases
