34
UTILITIES
The Utilities Menu contains the following:
A/B TEMPS
When this is set to On, the main screen will display sensor A and sensor
B temperatures simultaneously. Sensor A is at the opposite end of the
heater from sensor B.
DEMO MODE
Demo Mode is not always enabled, so it may not appear. This is de-
signed to operate several devices in a sequence in order to demonstrate
the various features of a particular hot tub.
FAULT LOG
The Fault Log is a record of the last 24 faults that can be reviewed by a
service tech. Use the Up and Down buttons to view each of the Faults.
When Priming Mode shows in the Fault Log, it is not a fault. Rather, it is
used to keep track of spa restarts.
GFCI TEST
(Feature not available on CE rated systems.)
Your systems may have GFCI configured in one of three ways:
1. GFCI test is not enabled
2. Manual GFCI test is enabled but automatic GFCI test is not enabled
3. Both manual and automatic GFCI tests are enabled. The automatic
test will happen within 7 days of the spa being installed and if success-
ful will not repeat. (If the automatic test fails it will repeat after the spa
is restarted.) GFCI Test will not appear on the screen if it is not en-
abled. This screen allows the GFCI to be tested manually from the
panel and can be used to reset the automatic test feature.
*M0XX is a Message Code. Codes like this will be seen in the Fault Log
ADDITIONAL SETTINGS
PREFERENCES
The Preferences Menu allows the user to change certain parameters
based on personal preference.
TEMP DISPLAY
Change the temperature between Fahrenheit and Celsius.
TIME DISPLAY
OWNER’S MANUAL
2017
Change the clock between 12 hr and 24 hr display.
REMINDERS
Turn the reminder messages (like “Clean Filter”) On or Off.
CLEANUP
Cleanup Cycle Duration is not always enabled, so it may not appear.
When it is available, set the length of time Pump 1 will run after each use.
0-4 hours are available.
DOLPHIN II AND DOLPHIN III (APPLIES TO RF DOLPHIN ONLY)
When set to 0, no addressing is used. Use this setting for a Dolphin II or
Dolphin III which is factory set for no address by default. When set be-
tween 1 and 7, the number is the address. (See the Dolphin manual for
details.)
COLOR
Selecting Color will cycle through 5 background colors available in the
control.
LANGUAGE
Change the language displayed on the panel.
INFORMATION
SYSTEM INFORMATION
The System Information Menu displays various settings and identification
of the particular system. As each item in the menu is selected, the detail
for that item is displayed at the bottom of the screen.
SOFTWARE ID (SSID)
Displays the software ID number for the System.
SYSTEM MODEL
Displays the Model Number of the System.
CURRENT SETUP
Displays the currently selected Configuration Setup Number.
CONFIGURATION SIGNATURE
Displays the checksum for the system configuration file.
