Coast Spas INFINITY EDGE SWIM Owner'S Manual Download

Page: 14 / 27

GATE VALVES:

Red with a grey handle is located at the

inlet and outlet of the pumping system. Used while servicing the
spa equipment, the valves open or close the water flow to the
equipment. To remain open for normal use, turn fully counter-
clockwise.

KNIFE VALVES:

A white “T”-handled valve, same functions as

Gate valve (see above), except to open them you pull up on
handle.

HEATER:

The electronically controlled heater raises the

temperature of the spa to the desired setting.

LEDs:

LEDs and their special lenses can be used to achieve

the desired mood lighting in the spa and spa jets.

SKIMMER:

This is the rectangular outlet at the water level.

The skimmer removes surface debris to the filter. The water
level in the spa should be kept ½ to ¾ up on the skimmer for
optimum operation.

SUCTION FITTING:

During operation of the equipment, the

suction works in conjunction with the skimmer to draw water
from the bottom of the spa through the filter, keeping the spa
sparkling clean.

NECK JET:

Direction-controllable jet for soothing neck mas-

sage.

ADJUSTABLE CLUSTER JET:

Our adjustable, high-intensity

hydrotherapy jet.

DIRECTIONAL JET:

Provides a straight flow for a therapeu-

tic massage

ROTATIONAL JET:

Provides a Uni-directional circular thera-

peutic massage.

MASSAGE JET:

Delivers massage in staccato bursts over a

narrow, focused area.

VOLCANO/WHIRLPOOL JET:

high-output jet designed for foot

and leg massage.

LAMINAR FLOW WATER FEATURE:

A thin stream of water

that arcs from the spa lip

BASIC INSTALLATION AND CONFIGURATION GUIDELINES

Warning! Qualified Technician Required for Service and
Installation

Use minimum 6AWG copper conductors only. Torque field con-
nections  between  21  and  23  in  lbs.  Readily  accessible  discon-
necting means to be provided at time of installation. Permanent-
ly connected power supply.
Connect  only  to  a  circuit  protected  by  a  Class  A  Ground  Fault
Circuit  Interrupter  (GFCI)  or  Residual  Current  Device  (RCD)
mounted at least 5’ (1.52M) from the inside walls of the spa/hot
tub and in line of sight from the equipment compartment.

OWNER’S MANUAL

2020

CSA ENCLOSURE: TYPE 2

Refer to Wiring Diagram inside the cover of the control enclo-
sure.
Refer to Installation and Safety Instructions provided by the spa
manufacturer.

Warning:

People with infectious diseases should not use a

spa or hot tub.

Warning:

To avoid injury, exercise care when entering or

exiting the spa or hot tub.

Warning:

Do not use a spa or hot tub immediately follow-

ing strenuous exercise.

Warning:

Prolonged immersion in a spa or hot tub may be

injurious to your health.

Warning:

Maintain water chemistry in accordance with the

Manufacturers instructions.

Warning:

The equipment and controls shall be located no

less than 1.5 meters horizontally from the spa or hot tub.

WARNING! GFCI OR RCD PROTECTION.

The Owner should test and reset the GFCI or RCD on a regular
basis to verify its function.

WARNING! SHOCK HAZARD! NO USER SERVICEABLE PARTS.

Do not attempt service of this control system. Contact your deal-
er or service organization for assistance. Follow all owner’s man-
ual power connection instructions. Installation must be performed
by a licensed electrician and all grounding connections must be
properly installed.
• Disconnect the electric power before servicing. Keep access
door closed.

CSA COMPLIANCE

Caution:



Test the ground fault circuit interrupter before each use of the
spa.



Read the instruction manual.



Adequate drainage must be provided if the equipment is to be
installed in a pit.



For use only within an enclosure rated CSA Enclosure 3.



Connect only to a circuit protected by a Class A ground fault
circuit interrupter or residual current device.