9
Step Three
: Left Panel Installation
IMPORTANT
–
The Infra-Tile
TM
floor heater’s cord connects to the bottom of the left wall
. With one person
holding the wall up at an angle, attached the male/female plug. Proceed with installing the left wall, while
feeding the wire down in the floors access hole. Be careful to not pinch this plug as you set the wall on the
base. Make sure to lock the panels properly as explained on page 5. For a one person install, a block of wood
or left over packaging can be put under one side of wall while plug is connected.
After connecting the white plug, carefully feed the wire in as the wall is lowered without pinching it.
Important: Double check the pins on the white connections that they are fully inserted into eachother.
Summary of Contents for Delmar Series
Page 20: ...20 Control Panel Instructions ...
Page 22: ...22 Step Fourteen SWEAT ...