Cobalt_OM_preprint_shell.fm Page 2 Wednesday, March 1, 2006 5:39 AM
5
-
8
222 Owner’s Manual
COBALT
222
BOWRIDER
S
ECTION
5
OTHER CANVAS
COMPONENTS
Clear Vinyl “Isinglass”
The clear vinyl “isinglass” used in side curtains, aft
curtains and visors is very reactive to heat and
cold. Carefully unroll the vinyl in cold weather to
avoid cracking. Keep vinyl side curtains from
touching the bows (tubing) to prevent burning the
vinyl. If boat is stored with top, side curtains and aft
curtain in place, heat buildup inside of the boat may
discolor the vinyl.
Use a soft, clean cloth with a solution of Ivory or
Lux soap, liquid or flakes, and lukewarm water.
Never use any harsh or abrasive cleanser; these
types of cleaners will scratch the glass. To keep the
vinyl soft and flexible, regularly apply UV screening
agent such as “303 PROTECTANT.”
• Do not fold or wrinkle curtains; roll smoothly
when storing.
• NEVER store the isinglass wet or in an
unventilated, moist area.
• Always roll the glass instead of folding.
• Handle the isinglass carefully. It is soft and very
prone to scratching.
Zippers
When zippers are new, they can be more difficult to
zip than when “used.” Zip carefully without forcing.
They will loosen with use. Keep the zippers clean.
A zipper lubricant may be used to help new zippers
and to maintain long trouble-free service. The most
vulnerable part of the zipper is where they start.
Use care when starting zipper to prevent damage.
Snap Fasteners
Fasteners should be unsnapped as close to the
button as possible. Never remove canvas by pulling
roughly on one edge of the material. This can
damage the canvas and the fasteners. To prevent
snaps from becoming difficult to unsnap, keep them
clean and use lubricants such a small amount of
Vaseline
®
, Chapstick
®
, WD-40
®
, silicone spray, etc.
The most common recommendation is to rub
candle wax or paraffin around the stud or inside the
socket. Whichever method is used, make sure you
clean up any excess so the lubricant does not stain
the canvas or any other surfaces it may contact.
WINDSHIELD
To keep the windshield clean, use a non-abrasive
glass cleaner applied with a soft cloth. Do not use
harsh detergents, solvents, chemicals or dry cloths.
These items will scratch the surface.
BILGE
Keep the bilge area as clean as possible. Use a
vacuum cleaner to remove debris from the bilge
area. Oil and greasy dirt will accumulate over time
and normally can be removed using soap and
water. If necessary, consult your authorized Cobalt
dealer for recommendations on special bilge
cleaning and absorption products.
MARINE GROWTH
If marine growth is a problem in your boating area,
it may be necessary to apply anti-fouling paint to
the hull to slow growth and prevent gelcoat
damage. Consult your authorized Cobalt dealer for
recommendations.
