18
5.
Enter the IP address of the gateway for your network. If your
network does not have a gateway, do not enter a number — press
the
button to accept the default value of
“000.000.000.000.”
Note:
A gateway or router address is not required for a Qube 2
that is only connected to a local area network (LAN). If you
connect to another network through the Qube 2, you require a
gateway address. If you use a modem to connect to the
Internet, the modem serves as the gateway.
6.
Press the
button.
The LCD displays:
[S]AVE [C]ANCEL
7.
To save the configuration information, use the left and right arrow
buttons to select [S]ave, and then press the
button. You’ll
see:
VERIFYING AND SAVING
Note:
Selecting [C]ancel cancels the configuration and the
LCD screen displays:
PRIMARY IP ADDR:
again. You must go
through the entry process again.
After verifying and saving, the Qube 2 completes the boot process. The
LCD screen shows several messages in succession before displaying the
IP address assigned to the Qube 2.
Configuration is complete when the LCD screen displays the IP address
assigned to the Qube 2, for example:
IP Address:
192.168.25.77
Enter
Enter
Enter
Summary of Contents for Cobalt Qube 2
