155
Appendix A
Using the LCD console
During startup, the LCD screen on the back of the Cobalt Qube 2
displays status information about the boot process itself.
When setting up the Qube 2, you use the LCD console to enter network
configuration information for the Qube 2.
Once the Qube 2 is running, the LCD console serves several purposes.
Through the LCD console, you can:
•
change network configuration information, which is useful if you
change the location of the Qube 2.
•
reboot the unit, which restarts the entire system.
•
power down the unit in a way that allows the Qube 2 to close all
open files and minimizes startup time the next time the Qube 2 is
powered on.
!
Caution:
It is important to follow the proper power-down
procedure before turning off the Qube 2. Refer to “Powering
down” on page 158.
You access each of these functions by holding down the
button
on the LCD console for approximately two seconds. This action causes
the LCD screen to enter its function mode. Press the
button
until the function you want appears on the LCD screen. To cancel the
LCD function mode, select the
EXIT
function when it appears on the
screen. Press the
button and select
YES
.
Select
Select
Enter
Summary of Contents for Cobalt Qube 2
