Chapter 4: To use the web interface
98-126882-F
To set up the interfaces
74
To configure the ISDN interface
To configure the ISDN interface, do as follows:
1. Select
SETTINGS
>
ISDN
.
2. Set the call type(s) for incoming calls.
You can select Standard, 3.1 kHz Audio, UDI and/or RDI.
3. Set the MSN (Multiple Subscriber Number) numbers that are to be assigned to each call
type.
Note that this setting only applies to the call type selected above the MSN number, and
only if the connected device supports the call type used.
Note
For information on how to set up call services (supplementary services), see
on page 78. These settings apply to both the Phone/Fax interface, the
ISDN interface and the LAN w. PoE interface.
Note
Connected devices will only receive incoming calls with the call types that are
selected here.
For example, if only Standard is selected, and a G4 fax call (using call type UDI)
arrives, a fax connected to the ISDN port will not receive the incoming call.
Important
If you set an MSN number to anything other than <None>, connected
devices must be programmed with these MSN numbers.
Summary of Contents for explorer 727
