Chapter 4: To use the web interface
98-126882-F
To set up the interfaces
75
You have the following options with the MSN numbers:
•
<None>
. No MSN numbers are used. An incoming call is accepted in all devices
connected to this port.
•
1*, 2*, 3* or 4*
: If, for example, you select 1* at Standard call type, an incoming
Standard call is accepted by all devices that are programmed with the number 1* and
connected to the ISDN interface.
•
0401, 0402:
These are local numbers for separate devices connected to the ISDN
interface.
An incoming call is accepted by devices that are programmed with the selected number
and connected to the ISDN interface.
You can combine the MSN settings.
Example:
You have two devices connected to the ISDN interface. One is programmed
with the numbers 1* and 0401, the other is programmed with 1* and 0402.
In the web interface, you select the MSN number 1* under Standard.
If an incoming Standard call arrives, both devices will accept the call.
If you make a local call to one of the local numbers 0401 or 0402, only the
called device will accept the call.
4. Set the call type for outgoing calls.
• If you select
Automatic
, the call type will be determined by the calling device.
• If you select
Standard
, all outgoing calls, except UDI/RDI, will use the call type
Standard. If you make a 3.1 kHz Audio call it will be converted to a Standard call.
Outgoing UDI or RDI sessions will be not be influenced by this setting.
• If you select
3.1 kHz Audio
, all outgoing calls, except UDI/RDI, will use the call type 3.1
kHz Audio. If you make a Standard call it will be converted to a 3.1 kHz Audio call.
Outgoing UDI or RDI sessions will be not be influenced by this setting.
5. If you hear an echo in your ISDN handset and the handset does not have its own echo
canceller, enable the
Audio echo canceller
.
6. At the bottom you can see whether or not Restricted dialing is enabled. For further
information, see
7. Click
Apply
.
Note
You can override the call type setting for outgoing calls by dialing one of the
following prefixes before the number:
• 1* (force the call to Standard)
• 2* (force the call to 3.1 kHz Audio)
Refer to
To override the default outgoing call type
Note
If you are using the ISDN port for ISDN data, make sure
the Audio echo canceller is
disabled
to avoid loss of
data.
Summary of Contents for explorer 727
