| 2021-08 User manual
Eclipse Tilt Wheelchair
12
Assembly and adjustment, continued
Adjusting The Seat-To-Height-Floor.
1. Remove the grub bolts that secure the upper
seat frame to the lower base frame; there are two
Allen bolts located on the outside of the
seating
plate (one screw on each side).
2. Move the seat frame to the desired height.
There are three height settings.
3. Remove the Allen bolt, which connects the
lower part of the gas strut to the base frame.
4. Move the lower end of the gas strut (Strut-A, -B
or -C) to fit the selected seat height (SH-A, -B or -
C) as shown.
5. Seating plate most be placed almost level when
the gas strut is fully extended.
All screws and nuts must be assembled
correctly.
6.7 Seat-to-Floor Height
1.The tilt angle is adjusted by activating the tilt
lever on the side of the push handle or on the
armrest, depending on how the wheelchair is
configured.
2. Lower the rear of the seat to the desired height
and release the tilt handle. The seat now 'locks' at
the desired tilt angle.
Be aware that the tilt handle may be mounted on
the left or right side of the push handle on the
backrest or on the left or right armrest.
When tilting the wheelchair, it is important to
hold the push handle firmly, so the seat does not
drop too quickly.
6.8 Adjustable seat tilt
The tilt restriction is a yellow telescopic tube next
to the gas strut. It has 6 holes for setting the tilt
stop.
Insert the shiny 10-
32” Allen screw into the
desired position.
After adjusting, the parts must always be
properly replaced and tightened before using the
wheelchair.
6.9 Tilt restriction
