10
Maverick Boat Group
3207 Industrial 29th St. • Fort Pierce, Florida 34946
(772)-465-0631
•
cobiaboats.com
Bilge
Bilge Access
Accessing the bilge in your 262 is made easy. First, locate the controls on the electronic
lift assist, labeled “Hatch”, mounted on the starboard side of the tackle station directly
across from the gunwale. Next, press and hold the top button on the controls. This will
cause the rear access to lift revealing the bilge access. To lower the hatch simply press
and hold the bottom button on the control panel until the aft section is fully closed.
Remember that the electronic lift assist operates using the house battery system.
In the event that the boat does not have power to electronically lift the hatch, the
electronic lift can be disengaged by lowering the bench
seat and using the access opening shown below to
remove the pin from the electronic ram. Keep in mind
that at this point the hatch will no longer be supported
in the up position and will require being held up to
maintain access to the bilge. Once the work in the bilge
is finished and power is restored to the hatch lift, it is
important to attach the ram to the hatch with the pin
once again to secure the door in the closed position.
Note:
The aft seat backrest must be removed to fully open the hatch.
Failure to remove the backrest will result in damage to the backrest
and possibly the hatch lifting mechanism.
Electric Ram and Hatch Pin
Electric Ram Override Access
Bilge Access
Hatch Control
