M o d e l Y e a r 2 0 1 9 p a g e 3 5
M a v e r i c k B o a t g r o u p , I n c . • 3 2 0 7 I n d u s t r i a l 2 9 t h S t . • F o r t P i e r c e , F l o r i d a 3 4 9 4 6 • ( 7 7 2 ) - 4 6 5 - 0 6 3 1 o r ( 8 8 8 ) - s h a l l o w • F a x : ( 7 7 2 ) 4 8 9 - 2 1 6 8
O P T I O N A L F E A T U R E S
Optional Windlass Deluxe
The windlass is used to lower and raise your anchor assembly. The switch is mounted
at the helm station above to the right of the steering wheel. The solenoid switch is
mounted to aft hull and the battery cables are run up the starboard side. The windlass
is mounted inside the anchor locker at the bow of the boat. To access this area, lift the
anchor hatch at the bow. A bow plate and anchor roller has been added to accept the
anchor and keep it far enough from the bow of your 301 CC to prevent damage to the
bow. The windlass is mounted just aft of the bow roller plate.
**WARNING: READ ALL OF THE INSTRUCTIONS BEFORE OPERATING THE
WINDLASS
Optional JL Audio Stereo System
If you chose the stereo option, your 301 CC came with a JL Audio stereo model Media Master 100 with 4 matching speakers
(4 extra optional t-top speakers). Please refer to the JL Audio Owner’s Manual in your ditty bag for operation. Even if your
boat didn’t come with the stereo, your boat is pre-wired for four speakers in the cockpit and for four speakers in the hardtop.
(Refer to pictures below for general locations of speakers and pre-pulled wiring.) Note that an amplifier is required to power
more than four speakers with this model JL Audio. The amplifier is standard along with the four speakers in the hardtop if the
boat has the speaker hardtop option.
Summary of Contents for 301CC
Page 38: ...301 Hull Wiring Harness...
