14
Maverick Boat Group
3207 Industrial 29th St. • Fort Pierce, Florida 34946
(772)-465-0631
•
cobiaboats.com
DC Main Breaker Panel
The DC main breaker panel is located to the left of the mirror and contains
the breakers for the accessories on the helm switch panel. If an accessory is
not working it may because its breaker has been popped. Simply find the
rubber button on the breaker panel for the associated accessory and press it
in. You should feel an internal button move in and then catch. This will
reset the breaker and close the circuit. If the accessory still is not working or
the breaker pops again, another issue is present.
The backside of the switch panel and the electronics can be reached inside
the door with the mirror. The fuse box on the back of the door contains the
fuses for the helm electronics such as the GPS units and VHF.
Electric Head Operation
To operate the head, first, make sure that the intake/fill valve located on the inside of
the bottom of the hull accessed through the hatch to the left side of the toilet. The valve
is open when its handle is pointing
straight up (pictured to the left). This
will allow water to enter the head
upon flushing.
Once you’ve finished using the head,
press the flush button labeled “Elec
Head” on the switch panel. This will
push the contents of the head into
the holding tank. Note that the toilet
contents will always go into the
holding tank first, no matter if
planning on pumping out or using
the macerator.
To evacuate the holding tank via a marina pump out,
make sure that the handle for the Y-valve (located in
the access hatch to the right of the toilet) is in the
correct position. This will allow the tank contents to
be sucked out of the tank via the waste deck fitting
on the deck. The discharge for the deck fitting will
always be the topmost outlet on the Y-valve. The
Main Breaker Panel
Intake/Fill Valve in the “OPEN” Position
Flush Button & Macerator Switch
