Instruction Manual - Original Version
Page 45 of 50
7.3.4
4
–
Printing area
After all operation involving fresh concrete (not for dry-runs etc.).
Thoroughly clean printing area, removing all excess materials from floor / ground.
7.3.5
5
–
Other equipment
After all operation involving fresh concrete (not for dry-runs etc.).
Thoroughly clean all additional equipment like buckets, shovels etc., and leave to dry outside printing area.
7.3.6
6
–
Excess / waste material
After all operation involving fresh concrete (not for dry-runs etc.).
Dispose of all excess material following local codes and material su
pplier’s directio
ns.
7.3.7
7
–
Extruder inner parts
•
Dismount PCP unit and rotational nozzle
•
Disassemble rotational nozzle parts.
•
Check for material buildup / hardened concrete and clean if necessary
•
Check state of bearings and clean / replace if necessary.
•
Check state of rubber belt and replace if necessary.
7.3.8
8
–
U-rails
Inspect all U-rails (located on X, Y and Z axes).
Remove all dust / oil / dirt gathered using high pressure water hose or similar.
7.3.9
9
–
Tooth rack
Inspect all tooth racks (located on X, Y and Z axes)
Remove all dust / dirt gathered using high pressure water hose or similar. Lubricate racks if necessary.
7.3.10
10
–
Lamp / lights
Inspect signal lamp and lights on printhead and main E-box.
Using a dry cloth, wipe lamp surface for dust / dirt.
7.3.11
11
–
Safety door latch
Inspect safety door latch
Using pressurized air, clean out all dust / dirt gathered. Lubricate latch if necessary.
7.3.12
12
–
Carriages
Using high pressure water hose or similar, clean all carriages.
Summary of Contents for BOD2-444
