Nothing
Comes Close to a Cobra
®
11
10 English
Installation
Your Detector
Installation
Your Detector
Battery Charging
The unit is shipped with a sealed lithium-ion (LiON) battery pack that is
rechargeable.
IMPORTANT:
Avoid temperature extremes (hot and/or cold) to help prolong
battery life and performance. DO NOT leave RDU exposed to direct sunlight.
If the RDU is mounted on vent, clip must be on lower fin to avoid hot air
blowing on RDU battery compartment.
NOTE:
When battery begins to discharge too quickly, it is time to
install a new battery.
1.
Attach 12V to 5V
retractable USB power
cable to bottom of RDU
and to 12V power adapter.
2.
Connect 12V power
adapter to vehicle
accessory outlet (cigarette
lighter plug).
3.
Initial charge for battery
is two (2) hours.
(RDU may be used while
charging.)
1.
Turn RDU over and slide
battery cover off the
RDU body.
2.
Carefully plug battery wire
connector into the battery
connection port in RDU.
Connector only fits one way.
3.
Replace battery cover.
Remote Display Unit (RDU)
•
Battery Installation
CAUTION
This lithium-ion (LiON) battery should only be recharged inside the
RDU. Do not substitute any other type of charging adapter or charging
base to charge the battery. Battery damage, fire or explosion may result.
NOTE:
Lithium-ion (LiON) batteries are toxic. Please dispose of properly.
Some municipal waste disposal agencies have special provisions for
battery disposal.
NOTE:
After battery is fully charged, unit can be operated without
retractable power cord until battery needs recharging.
