Notice
Caution
Warning
2 English
You should find all of the following items in this package:
Intro
Operation
Customer
Assistance
Warranty
Notice
Secondary Icons
Caution
Warning
Installation
Customer
Assistance
Introduction
3
Installation and Start-Up
Intro
Operation
Customer
Assistance
Warranty
Notice
Secondary Icons
Caution
Warning
Installation
Customer
Assistance
Installation
Included in this Package
Intro
Operation
Customer
Assistance
Warranty
Notice
Secondary Icons
Caution
Warning
Installation
Customer
Assistance
Introduction
Select a location for the transceiver and microphone bracket that is convenient for
operation. In automobiles, the transceiver is usually mounted to the underneath of the
dash panel, with the microphone bracket beside it.
A universal mounting bracket is supplied along with self-tapping
screws and star washers. The transceiver is held in the
universal mounting bracket by two thumb screws, permitting
adjustment at the most convenient angle.
To mount and connect your transceiver:
1.
Hold the radio with mounting bracket in the exact
location desired. Remove the mounting bracket
and use it as a template to mark the location for
the mounting screws.
2.
Drill necessary holes and secure mounting
bracket in location.
3.
Connect the antenna cable plug to the receptacle
marked “ANT” on the back of the unit.
4.
Connect the red lead of the DC power cord
to an accessory 12 volt fuse.
5.
Connect the black lead to the negative side
of the automobile. This is usually the chassis.
Any convenient location with good electrical
contact (remove paint) may be used.
6.
Mount the microphone bracket in a convenient location
that does not interfere with vehicle operation using the
two screws supplied.
7.
Connect the microphone RJ-45 plug to the 19 MINI RJ-45
front panel jack. Then install the radio into it's mounting
bracket securely.
Intro
Operation
Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Caution
Warning
Installation
Customer
Assistance
CB Tranceiver
Transceiver Bracket
Fuse Connection
Antenna Connector
Intro
Operation
Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Caution
War
ning
Installation
Customer
Assistance
Microphone Connector
Intro
Operation
Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Caution
War
ning
Installation
Customer
Assistance
Operation
NOTE
For improved CB radio performance,
connect the radio power leads directly to the
vehicle battery
. This helps to ensure the following: 1) reduces conducted power line noise
into radio by taking advantage of the mechanical filtering properties of the vehicle battery.
2) Using the correct wire gauge between the battery and radio, helps to minimize Voltage
drop to the radio transmitter section to maximize transmitter RF output power.
CB Transceiver
Microphone
Transceiver Bracket
Microphone Bracket
Operating Manual
Mounting and Connections
•
